Use this mode to verify commands that you have entered. While in user EXEC mode, enter the enable To access each one, the prompt you see in that mode, and how to exit the mode. This table describes the main command modes, how From global configuration mode, you can enter interface configuration mode and You must start at global configuration mode. To access the various configuration modes, The configuration, these commands are stored and used when the switch reboots. Using the configuration modes (global, interface, and line), you can make changes to the running configuration. From this mode, you can enter any privileged EXEC command or enter global configuration mode. Normally, you must enter a password to enter privilegedĮXEC mode. To have access to all commands, you must enter privileged EXEC mode. The userĮXEC commands are not saved when the switch reboots. Show commands, which show the current configuration status,Īnd clear commands, which clear counters or interfaces. Most of the user EXEC commands are one-time commands, such as Only a limited subset of the commands are available in user EXEC mode. When you start a session on the switch, you begin in user mode, often called user EXEC Enter a question mark (?) at the system prompt to obtain a list of commands available for each command mode. The commands available to you depend on which mode youĪre currently in. The Cisco IOS user interface is divided into many different modes.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |